About
A bead and wire vine for hair
A hair vine is a wire with beads etc on it that you put in your hair in lots of different ways.
You can attach hair clips, elastic, wind it round a bun etc.
You Will Need
-
Step 1Get your tools, wire, beads and tape measure together.
-
Step 2Measure 70 inches/178cm of wire and cut it.
-
Step 3Bend the wire in half and make a loop by twisting the wire. Twist it for about an inch, I use the tip of my thumb to the knuckle as a guide.
-
Step 4Thread beads onto one of the wires
-
Step 5Twist that wire back on itself so you have a branch about an inch long
-
Step 6Then twist the wire for another inch and make a branch on the other side. Keep doing this for most of the length.
-
Step 7Leave some wire at the other end to make another loop.
-
Step 8Make the loop about an inch from your last branch and twist the wire back onto itself up to that branch
-
Step 9Cut the wire ends off and make sure they are not sticking out. I flattened the loop a bit with some flat pliers too.
now you have a hire vine to do with as you wish. As I have short hair I put some elastic on mine and use it as an alice band but sometimes put hair grips in it so I can put it in anyway I wish
Comments
