Diy Earring Jacket

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  You will need the following:

• 

  Step 2

  Now lets get to work, you will need to first cut out the plastic into four strips, then place your strip over your earlobe tracing which I had done using using pen/marker. Next, Use your bare hands or in my case a plucker for a better hold of rhinestones to glue the base of it, which is to be applied on the plastic.

• 

  Step 3

  Now follow the same step and glue down the rhinestones around the lining of your earlobe tracing carefully . I used 5 rhinestones, it depends on the size of your earlobe really.

• 

  Step 4

  You can now push the pin against the the dot(ear piercing trace) and then pick it up to stress it, to make a hole just enough to be able to insert your stud .

• 

  Step 5

  After getting your hole right ,you ought to cut off the excess plastic and create an inverted T shape as shown in the picture

• 

  Step 6

  You are done, congratulations now you can put your stud on and then follow it by the ear jacket you just created.
  Also I followed the same procedure and ended up with this pearl ear jacket.

Comments

Leave your comment