Swirly Wire Bracelet

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  You don't have to cut wire from the bundle to make this bracelet.
  Hold the wire from any one end from the bundle,
  Leave 3-4 cm of the wire straight and then bend the wire,
  Tighten the bend using the flat nose plier.

• 

  Step 2

  Bend the wire again by using the looping plier to create a hook-like pattern.

• 

  Step 3

  Now, coil the 1-1.5 cm of the extra straight wire around the longer wire piece.

• 

  Step 4

  Create the first loop near the hook by using the looping plier, keep 0.5-1 cm gap between the hook and the loop.
  Circle the wire around that loop 2-3 times to make the first swirl, don't circle the wire more than 3 times otherwise you won't get a smooth round shape for the bracelet.

• 

  Step 5

  After completing the first swirl make another loop near it by winding the wire in the opposite direction of the previous loop, keep 1 cm gap between the swirl and the loop,
  Circle the wire around that loop for 2-3 times to make another swirl.
  Keep repeating the steps until you the bracelet reaches its required length.

• 

  Step 6

  When you'll think that you've made enough swirls for the bracelet hold it straight with a ruler to check if the size is right.

• 

  Step 7

  After measuring the length bracelet cut the wire from the bundle by keeping 3 cm extra on the wire.
  Use the looping plier to create a loop with the extra cms' near the last swirl,
  Coil the remaining wire below the loop.

• 

  Step 8

  Wrap the swirl-chain around any round object that matches your hand size and attach both ends together through the hook and loop.

• 

  Step 9

  Use the flat nose plier to flatten the swirls,
  Press the swirls against the round object to flatten the swirls and give the bracelet a smooth round shape.

  Done!

Comments

Leave your comment

Vallie H. · Hartford, Michigan, US 1st April 2015

that was easy enough! i am going to incorporate it into another project. tyvm!

Reply