Spiral Bound Sticky Note Holder

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Cut 3 pieces of card board and 3 pieces of Kraft paper to 9cm x 10cm.

  I save all the card board protectors from packs of designer paper or the backing for paper pads.

• 

  Step 2

  Punch the holes for the notebook spiral using your binding machine along the 9cm side.
  For the Cinch I pulled out Notch 7 to prevent getting a hole too close to the right hand edge - you will need to adjust to your own machine.

• 

  Step 3

  Stick your sticky notes to two of the three pieces of card board and then cut your notebook spiral to size using wire cutters.

• 

  Step 4

  Attach your spiral to the loading teeth on your binding machine (if there is one) Stack up the 3 card board pieces with the front and back outsides facing each other and the first internal page under the cover page. With the inside back cover on top thread the 3 pieces onto the notebook spiral, then use the closure press on your machine to bring the spiral to meet in the middle.

• 

  Step 5

  Decorate the front cover as desired. I used Watercolour paper and water coloured using an aqua painter and ink refills. Once the back ground was dry I stamped over the top with the same colour ink and added a die cut in the same colour paper.

Comments

Leave your comment