About

Cost
$ $ $ $ $
Difficulty
• • • • •
Time
1h00

+ Flower Christmas ornaments
FINISHED SIZE: ø16cm (6”)

Subscribe to the Photobeads Pattern Express (http://www.photobeads.eu/en/pattern-express) and receive all projects from Photobeads free of charge in your inbox monthly!

Posted by Photobeads from The Hague, South Holland, The Netherlands • Published See Photobeads's 30 projects »
Tags

PrintEmbed
  • Step 1

    Using your round nose pliers make a loop on one end of the memory wire. String three photother end of the memory wire make a loop connecting the two ends of the wire.

  • Step 2

    Arrange the pine tree branches around the wire circle in the way you would like them to be on your wreath. Spread the photobeads over the wire.

  • Step 3

    Cut the black wire in equal pieces, one piece per branch. Fix branches on the wire circle using your black wire pieces.

  • Step 4

    Take the tops off the Christmas balls and remove the wires. Attach a wire piece from a Christmas ornament to the wire circle underneath the branches. Slide the top back on in such a way that the wire stays attached to the wreath. Put the Christmas ball back on. Repeat this with all the Christmas ornaments.

  • Step 5

    Use the yellow satin ribbon to tie a bow on one side of the wreath. Tie another bow on the other side using the light green ribbon.

  • Step 6

    Wrap the red ribbon around the wreath leaving equally long ends free on each side. Use the free ends of the ribbon to make a bow on top of the wreath or to create a loop for hanging

Made this project? Share your version »

Comments