About

Cost
$ $ $ $ $
Difficulty
• • • •
Time
2h00

The sound of happy birds in the springtime always lift my mood – this mixed-media, multi-dimensional pendant celebrates the birds of springtime.

Posted by Cindi B. from Goldsboro, North Carolina, United States • Published See Cindi B.'s 7 projects »
PrintEmbed
  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 1
    Step 1

    Trim Faith is a Bird verse sticker to fit inside bezel.
    Seal with Paper Sealer.
    Place verse into bezel.

  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 2
    Step 2

    Trim piece of faux birds nest, or use dried grass to create nest, to fit inside bottom portion of bezel.

  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 3
    Step 3

    Mix ICE Resin® per manufacturer instructions, pour into bezel.

  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 4
    Step 4

    Sprinkle copper colored glitter along left and right edges of sticker.

  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 5
    Step 5

    Coat twig with ICE Resin®. Set onto filled bezel extending beyond bottom of nest. Let resin cure in bezel and on twig.

  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 6
    Step 6

    Create 3 miniature eggs from Natural Makin’s Clay®, let dry and then seal with ICE Resin®. Let dry. Mount inside nest. Add small feathers as accent inside nest.

  • How to make a resin pendant. "Faith Is The Bird" Mixed Media Pendant With Ice Resin® - Step 7
    Step 7

    Measure and cut strp of coordinating opaque silk ribbon to hang pendant.
    Place through bottom hole on bezel, extending about 1 1/2″. Bring up along back of bezel, and place through top loop on bezel. Loop ribbon around and tie knot at loop. Extend end of ribbon down and twist around ribbon on back of bezel, and extend beyond base of bezel approximately 2″.
    Use hot glue to mount brass bird charm to ribbons extending off bottom of bezel.

Made this project? Share your version »

Comments