DIY Snowflake Christmas Card

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Prepare your card into any size you want. Draw a simple snowflake pattern on the front side of the card. Place the card on a piece of scrap paper before starting the next step.

• 

  Step 2

  Use the craft glue tube (or make your own glue cone using plastic paper) to trace along the snowflake design. Neatly trace out the design. Do not apply too much glue otherwise it will get smudged and ruin the design.

• 

  Step 3

  Now sprinkle glitter powder on the glued design. Try to cover the whole design evenly and leave it like that for a while. After a minute or two remove the extra glitter powder from the card on the scrap paper by tapping the card vertically against the scrap paper. Pour back the extra glitter powders to the packet.

• 

  Step 4

  After another 2-3 minutes use a small brush to remove the extra glitters from around the design or you may also keep them if you wish to.

Comments

Leave your comment