Cut 2 strips of leather lace. Depending on your wrist size and how loose you want your bracelet, make them between 60 and 80 inches each. You can make up for a too short lanyard by adding extra chain but really, you want these to fit loose, like a bangle. So start with too much and cut away unwanted at the end.

To begin, find the middle of one of your laces and wrap it twice around your finger. Find the middle of your second lace, slide it under both loops, bring one side over and under then repeat with the other side ...slip off your finger and tighten

Getting the first and last stitches done are the most difficult, so watch these videos for help, but otherwise it's just loop/loop opposing laces then loop over and under and over and under with the leftover laces, then pulling it tight.

To secure the end knot, leave your last box stitch loose then with each lace, loop around your nearest loop/under/up through the center ...all the way around. Watch video here ...trim your leather ends as much as you'd like. {also see last photo above}

Using your pliers, open a link in your chain . . .

. . . and loop it through one {or two} of the loops at the end knot. Add extra chain if you like.

Open another chain, add it to your lobster clamp and loop it through the top {opposite side} or your lanyard.