https://www.cutoutandkeep.net/projects/cute-halter-from-baggy-t • Posted by Brittany Marie
-Take the shirt you want to use and measure how long you want the section under the bust to be. -Mark this length out with Chalk. -Measure the length around your torso, (under your bust) and divide that measurement in 1/2 and mark this at the top of the section you are going to cut. (mark it out in the center) -Draw a diagnal line from the top of the measurement to the bottom of the shirt. (Note the red section)
-cut along the diagnal lines and the shorter line from the bust measuremnt. -face the outside of the fabric into each other and stitch it up on both sides. -you now have the bottom portion of your halter.
-Take one of the sleeves and hold open the tube. -cut both of the sides of the tube so that you have two pieces. - If the hem of the sleeve is still intact, then you can use it for the next step, otherwise create an inch hem on each.
- Take the tube from step 2 and fold down an inch hem inside of the shirt and stitch it using a wipstitch. -attach the sleeves to the top of the tube. -Take the excess fabric and cut three strands. -Thread one through each hem of the sleeves, so that a piece of fabric is coming from each side. -Cut two holes in the back of the halter where the hem is. -Feed the third piece of fabric through.