Wrap With Wire

This electrifying set will add a spark to any outfit!

Posted by Beads Unlimited

About

Share

You Will Need (8 things)

  • 0.6mm coloured Wire aqua
  • 1 m heavy Chain silver plated
  • 25 x 5mm Jump Ring(s) silver plated
  • 12 x Eyepins silver plated
  • 2 x 16mm Glass Pearl Beads turquoise
  • 2 x 16mm Glass Pearl Beads magenta
  • 1 x 15mm Trigger Clasp silver plated
  • Pliers

Steps (5 steps, 50 minutes)

  1. 1

    Cut approximately 45cm of wire and wrap tightly around the aluminium circle. Join the ends together by twisting
    with pliers and bend in any sharp edges. With the round nosed part of the pliers tweak each loop of wire to tighten. Make two more.

  2. 2

    Thread a glass pearl onto an eyepin, trim approximately 1cm above the bead, bend into a loop and close.
    Repeat for the other pearl beads.

  3. 3

    Open a 5mm jump ring, attach to one end of a blue beaded eyepin, loop it through the wrapped wire at 12 o’clock on an aluminium bead and close the jump ring. Loop the next jump ring through the wire at 3 o’clock, attach a pink beaded eyepin and close. Join the next aluminium circle just outside the centre on both sides. Attach the next pink beaded eyepin and add the last aluminium bead to mirror the first.

  4. 4

    Cut two 15cm lengths of heavy chain and with a jump ring attach one to each of the blue beaded eyepins. Attach a jump ring to one end of the chain and a jump ring with trigger clasp to the other.

  5. 5

    This is what your finished necklace should look like.