Wooden Branch Buttons

How To-sday - Wooden Branch Buttons

Posted by Shrimp Salad Circus

About

I took full advantage of winter break at my parents' house. They have a spacious garage chock full of every tool imaginable, and I was in heaven. I took the dogs out for a walk to the park one afternoon and found a couple perfect branches, so I couldn't pass up the opportunity to make these darling little buttons!

Share

You Will Need (8 things)

  • hardwood Branch(es)
  • small hacksaw or table Saw
  • fine-grit Sandpaper
  • Safety Glasses
  • Drill or Dremel
  • thin, sharp object or Pencil(s)
  • Wood Polish (such as Johnson Wax or Pledge)
  • soft Cloth or paper towel

Steps (7 steps, 40 minutes)

  1. 1

    Begin by using a sharp tool or a pencil to mark the intervals where your buttons will be cut. You want them to be relatively thin, but they should not be so thin that they risk snapping. I found that they should be at least 1/8" thick. I marked next to my notches in yellow so that you can see them more clearly.

  2. 2

    Cut the end of the branch using the hacksaw or electric table saw. The project is admittedly far more tedious when sawing by hand, but I wanted to show that this could be done without any major tool investment. If you do have an electric saw, I would recommend using that for expediency. Of course watch your fingers, and wear your safety glasses!

  3. 3

    Place the sawed end of the branch over the edge of your work surface, and saw through the first line you've marked off. Once you've sawed that button off, continue until you have as many as you'd like.

  4. 4

    Using your drill or Dremel with a very fine drill bit, carefully position your bit just left of center and drill through the button. I drilled atop an old piece of wood to protect my work surface. Repeat with the other side of the button to create two holes for sewing. If you prefer the look, then you can drill four holes instead.

  5. 5

    One you've drilled through all your buttons, lightly buff each side with sandpaper to remove any edges that could snag clothing or other fabric.

  6. 6

    After sanding, simply polish each button on both sides with a wood product, such as furniture polish or the like. This will seal the buttons a bit and give them a more 'finished' look. I used Murphy Oil Soap on mine because it was all I had on hand, but it's really more to clean than polish. I'd recommend a polish or wax for this step.

  7. 7

    There you have it - as many cute little wooden buttons as you'll ever want. You don't need to buy any expensive tools, and you'll save a lot in the long run over ordering wooden buttons online.