Wire Wrapped Pendant
copper wrapped pendant and bail
Posted by Angel
About
If this has been done before I'm sorry. I just finished this and thought it might be nice to share. With a bit of practice it becomes easier to bend the wrapped bail into itself.
Share
You Will Need (6 things)
- 1 Pendant(s)
- 2 Copper Wire
- 1 Wire Cutters
- 1 Chain Nose Pliers
- 1 Bead Caps
- 1 Round Nose Pliers
Steps (3 steps, 45 minutes)
-
1
I used a thick gauge coper wire and a thinner gauge. Pick you gauge based on the size of the pendant. Feed both wires through the pendant.
-
2
Twist the thin gauge wire around the thicker gauge and then wrapped around the base of the pendant continue to wrap up the pendant about one and half wraps.
-
3
When I got to the top I began wrapping the larger gauge wire at the top. Wrap it very tightly and close together. When I wrapped enough I cut both wires. Then I used my round nose pliers to gently bend the bail into the hole of the pendant. Be careful because the thinner wire likes to straighten out as you bend.