Wire Button Bracelet! <3
A super cute, easy project :D
Posted by Fashionisda T.
About
A simple and quick project. <3
Share
You Will Need (3 things)
- Wire
- Button
- Scissors
Steps (9 steps, 900 minutes)
-
1
You'll need a pair of scissors, a wire, and a button. I forgot to take a picture of the button -_-;;
-
2
Measure around your wrist. Add about 2-3 extra inches on the wire and cut. Then, cut 3 wires of the same length.
-
3
Tie the wire. Leave about an inch allowance on the top.
-
4
Braid down. If you want more volume on your braids, make them loose. If you want a tight braid, tighten the braid as you go.
-
5
Take the button. Insert 2 strands of wire into the button. Leave the 3rd strand.
-
6
Take the 3rd strand. Insert it through the opposite side and pull down.
-
7
Continue braiding.
-
8
Tie a loop on the opposite side. Make sure that the loop is not too tight or too loose.
-
9
Cut off the excess wire.
I used the excess to make a ring.