Statement Bib Necklace
Easy necklace how to
Posted by Hella
About
This is an easy to make bib necklace made from cardboard, paper and self-sticking foil-like isolation tape. I bought it at my local euro-store but I'm sure they also sell it at do-it-self shops.
Share
You Will Need (10 things)
- Cardboard
- Thick Paper
- foil isolation Tape
- Scissors
- Jewelry Pliers
- Spray Glue
- 12 Jump Ring(s)
- small Chain
- Clasp(s)
- thick Needle
Steps (6 steps, 60 minutes)
-
1
Cut two moon-shapes using the bowls/cups/plates to measure. You can make them as small or big as you like. The big one is approximately from thumb to pinkie.
-
2
To make the shapes stronger but not too thick, glue them on paper with spray glue, and cut it out.
-
3
Do it again with the other side of the shape.
-
4
Cut small pieces of tape, remove the sticker and wrinkle the tape carefully. cover the shapes with the wrinkled pieces of tape.
(Sorry for the dirty hands, I have been painting today)
-
5
Decide were you want the little holes so you can attach the two shapes. Make the hole with a needle. Make sure you don't make them to close to the edge. Attach the two shapes using 5 jump rings on both sides. Attach the chains to the corners of the small shape using a jump ring and attach the clasp in the middle of the chain.
-
6
It's kind of hard to see, but you can see where I attached the two shapes on 1/4 and 3/4 of the big shape.
I think the necklace would look good on a collared shirt or a woolen sweater.