Spring Rose Flower Crown

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Wrap 2 of the pipe cleaners together at their ends. Fit the pipe cleaners around your head to see if they sit easily while leaving a little bit of wiggle room. If it does not fit, wrap your third pipe cleaner onto both of the loose ends of the other 2 pipe cleaners to finish off the ring. The final piece will look wobbly and bent but this does not matter, in fact it makes it looks more like a branch that way.

• 

  Step 2

  Carefully wrap your pipe cleaner ring with floral tape. This type of tape sticks to itself so don't worry when you first feel it and it seems too paper-y. For extra support, glue down the ends once you've wrapped it entirely.

• 

  Step 3

  Take your fourth pipe cleaner and cut a piece about 1 1/2 inches long. Wrap that piece once tightly around your taped ring. This will support the flowers when you glue them on.

• 

  Step 4

  Add a line of glue from the middle of the flower to the base of the leaves opposite each other (basically a straight line).

• 

  Step 5

  Place the flower on the base you created and add more glue if it is too loose.

• 

  Step 6

  Repeat the last 3 steps with the rest of your larger flowers. We used 4 large flowers.

• 

  Step 7

  Gather all of your supplies.

• 

  Step 8

  Add your smaller flowers in the gaps between the larger flowers to give the crown a little more variety and volume. We also added a few leaves at the ends to give it a wreath-vibe. There you go! Isn't it just lovely? Happy spring everyone!

Comments

Leave your comment