Sketch To Pumpkin Carving
Carve a symmetrical and detailed pumpkin the easy way.
Posted by Cat Morley
About
Share
You Will Need (5 things)
- Pumpkin
- Piece of Paper
- Pencil(s)
- Pin(s)
- Carving Knife
Steps (11 steps, 30 minutes)
-
1
Start off with a nice shaped pumpkin and pick the best side for placing your design on.
-
2
Take a sheet of paper, fold it around your pumpkin and mark out the outlines of the pumpkin on to the paper.
-
3
Fold the piece of paper in half at the middle. Sketch out half of the design on one half of the paper.
-
4
Fold the paper back in half and use a pin to prick through the paper around the design.
-
5
Fold it back half, your design should now be on both halves of the paper and meet in the middle perfectly.
-
6
It helps to lightly sketch over the rest of the design pin pricks, so that there's no confusion over which line goes where.
-
7
Now it's time to carve your pumpkin. It's best to cut off the lid in a zig-zag carving, so that the lid will fit in place nicely. (Remember to keep the filling to making Pumpkin Pie and Toasted Pumpkin Seeds.)
-
8
Tape the design to the front of the pumpkin so that it is secured in place.
-
9
One again, pierce around the design and in to the pumpkin.
-
10
After piercing around the entire design, remove the paper to reveal a neat outline for carving on the pumpkin.
-
11
Carve out the design, place a candle in the center of the pumpkin and enjoy the warm, eery glow!