About

Cost
$ $ $ $ $
Difficulty
• • • • •
Time
30 mins

A one-eared Gir charm from shrink plastic.
Out of all my numerous shrink plastic failures, this one turned out the best. His ear fell off but oh well... I need some help too, all of my shrink plastic likes to shrink up and shrivel and not unshrivel. It's annoying, and i burnt all ten of my fingers on Gir haha. Hope you like him! :)

Posted by katcar~ Published See katcar~'s 27 projects »
Tags

PrintEmbed

katcar~ posted this project as a creation without steps

Here are some similar tutorials to help you make this one!

Made this project? Share your version »

Comments

katcar~
katcar~ · 27 projects
thanks Happy i was following the directions, but i ruined 3 batches/sheets of shrink plastic... i might try again later, thanks!
Reply

CO + K User

Shrink plastic will move toward the heat source, so if you're using a heat gun move it away slightly, the edges of what you're heating will "follow" it=)
If you're using the oven maybe you've got it set too high. 350F for 1-4 mins depending on the size of the piece.
Reply