Russian Easter Eggs

A fun way to create hollow, decorative Easter eggs.

Posted by Uniquely-YZ

About

It's a great project for those rainy April days. My sister, aunt, and I spent a whole afternoon making these together (makes me wish I was back in Oregon).

This project really is not that hard, but it might take some time to get the hang of hollowing the eggs.

Share

You Will Need (8 things)

  • White, Medium Sized Egg(s)
  • Decorated/Colored Napkins
  • Paint Brush
  • Bowl(s)
  • Sewing Needle
  • Push Pins
  • Mod Podge
  • Colored Ribbon

Steps (17 steps, 120 minutes)

  1. 1

    First make sure your egg is nice and clean.

  2. 2

    At the top of the egg (the more narrow end), use the push pin to carefully puncture the egg shell and create a small hole. Make sure to do this step (and the next few steps) over a bowl so you don't make a mess.

  3. 3

    Do the same to the opposite end of the egg (this hole should be slightly bigger).

  4. 4

    Use the sewing needle to puncture the yolk by inserting the needle into the bigger bottom hole. (Move the needle around to make sure you break the yolk).

  5. 5

    Now, by carefully holding the egg over the bowl, gently blow into the smaller top hole. It's ok to blow harder (the egg will be fine). What's left of the egg yolk should come out pretty easily. (if not, try using the sewing needle to make sure the yolk is broken). (Still having problems? Carefully make the bottom hole bigger by chipping the edges away with the pushpin).

  6. 6

    Time to clean up. Hold the egg under the sink and allow warm water to enter the egg from the two holes. After you are sure that the inside is clean, blow out the excess water.

  7. 7

    With the egg yolk, I made breakfast. Waste not!

  8. 8

    Grab some napkins and tear out the designs you like. (You can cut them out, but it looks nicer if the edges are torn.)

  9. 9

    Most napkins have two layers, a white one and the decorated one. Pull the white layer off and only ues the colored side to decorate.

  10. 10

    Using the paint brush, place a thin layer of mod podge on the area of the egg you wish to decorate.

  11. 11

    Place the selected napkin piece onto the glue. Add some more glue on top of the piece and use the brush to smooth it over the egg.

  12. 12

    Continue until the entire egg is decorated. I wanted mine to look like it was covered in leaves. (To avoid touching areas that are finished, you can insert a long stick/chopstick/skinny pencil/screw driver into the larger hole to hold the egg up.)

  13. 13

    After the glue has dried, add a full layer of mod podge on the egg. Allow to dry.

  14. 14

    Once dry, take the ribbon (about 7 inches long..)and fold it in half. Tie a knot with the two loose ends.

  15. 15

    Insert the folded end with the needle into the larger bottom hole of the egg.

  16. 16

    To make the ribbon go all the way to the other hole, use the sewing needle/chopstick/pencil to carefully push the ribbon where you want it to go. The knot should stop the ribbon from slipping through the egg.

  17. 17

    To ensure the ribbon stays where you left it, glue the ribbon in place. Allow for dry time. And... ta da! Your done. Enjoy.