Pewter Button Bracelet

Button Lover's Jewelry

https://www.cutoutandkeep.net/projects/pewter-button-bracelet • Posted by GMC Group

You will need

Assorted pewter Metal Buttons (we used 18) 1 yd Each of brown and green Suede Cord 10 in Length of bronze large link ß at Chain Pewter metal Zipper pull Two 12mm 16 gauge silver oval Jump Rings 6 mm Silver Jump Rings Silver Toggle Clasp Chain Nose Pliers (2 pair) Wire Cutters

Project Budget

Time

Difficulty

Description

Instructions

1. Attach one oval jump ring to each clasp piece Place the clasp pieces together. Measure the distance from the end of one ring to the end of the other ring. Measure your wrist and decide how loose you want your bracelet; subtract the length of the clasp and rings. Cut the chain to the determined measurement.

2. Tie the ends of each cord length together. Place the knot at the end of the chain.

3. 

   Working with the brown cord only along the right side of the chain, bring the cord through the link from the back to the front. Bring the cord around the link and through the loop; tighten. Continue in this manner along entire right side of the chain.

4. Repeat Step 3 with the green cord along the left side of the chain. Knot the cords together at the end. Trim the cord ends.

5. Attach the zipper pull to a link in the chain near one end.

6. Attach buttons with small jump rings.

7. Use the large oval jump rings to attach the toggle clasp pieces to the end links of the chain.