Origami Balloon Lights

a super fun decoration that will look good throughout the year

Posted by Ghosts are Green

About

Paper should be cut into a square. squares that are 3x3 in. turn into really tiny balloons, they would probably work if you're using LED lights. I would suggest using paper that is 5x5 or 6x6 in., most origami paper comes in 6x6.

If you're using pre-cut origami paper, follow the tutorial to enough balloons to cover your lights. when you're done, stick the light through the hole that you used to blow up the balloon.

If you're using wrapping paper follow these steps:

Share

You Will Need (7 things)

  • String Of Light slike the ones that you use to decorate Christmas trees. you can use LEDs or the regular ones.
  • Scissors
  • Scissors or you could use a wrapping paper cutter
  • Paper Trimmer you won't need this if you're using origami paper thats already in the size you want
  • Iron And Something Heat Resistantthis is for people that are using wrapping paper. you will need something heat resistant to cover your paper while ironing so it doesn't burn
  • Origami Or Wrapping Paper
  • Ruler

Steps (1 step, 180 minutes)

  1. 1

    1. (*You can skip this step if you don't mind using slightly folded up wrapping paper) set up your iron (I used a Heidi Swapp mini craft iron, if you're using a iron with settings you should probably set it up on the lowest setting)

    2. using a ruler, mark off where you want to cut out your pieces. then use the scissors to cut a strip of paper that will fit the trimmer. (or you can just cut out the individual squares with the scissors, I think that the trimmer method is easier and you get more even squares)

    3. put the heat resistant sheet over the wrapping paper and iron until it lays flat

    4. follow the tutorial to enough balloons to cover your lights. when you're done, stick the light through the hole that you used to blow up the balloon

    hope everyone enjoys :)