No Sew Pleated Lampshades
No Sew Pleated Lampshades
Posted by Mark Montano
About
Makeover all of the lampshades in your house with this easy tutorial!
Share
You Will Need (4 things)
- Fabrics
- Bias Tape Maker
- Hot Glue Gun
- Wire Lampshade
Steps (3 steps, 120 minutes)
-
1
Lampshade with wire base
Glue gun
1/2" Bias Tape Maker
Iron
Fabric
Ruler
Scissors -
2
Watch the video tutorial
-
3
1. & 2. Remove the cover from the old lampshade and scrape off any glue with a craft knife
3. Fold the fabric on a diagonal matching the straight edges
4. 5. & 6. Measure 1" lines from the diagonal fold and then cut the fabric in 1" wide strips
*Cutting on the diagonal is also known as cutting on the bias which is why it's called bias tape
7. Thread the 1" bias strips through the bias tape maker and iron as you pull it from the tip
*This is how you make bias tape
8. & 9. Hot glue the end of the bias tape to the rim of the wire shade and start wrapping from top to bottom overlapping every 1/4" to 3/8"
10. & 11. Optional: Trim the shade by hot glueing the edge of piece of bias around the rim. Finish it by folding over the raw edge 1/4"
12. Glue the other edge of the bias on the inside of the shade
Make a pendant or add them to a fun lamp base and you're done!