No Sew Furniture Cover

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Measure the piece of furniture where you'll put the cover on. I'll be using this storage thingy where i keep my sneakers. My cover will measure 32x70cm so i drew that over my fabric.

• 

  Step 2

  Iron the fabric through the lines you drew so that you have a nice and clean fold.

• 

  Step 3

  Cut the excess of fabric.

• 

  Step 4

  Cut a little triangle on each corner so that when you glue everything there's not an excess of fabric there.

• 

  Step 5

  Glue everything! If your fabric isn't very thick make sure you don't add too much glue.

• 

  Step 6

  After folding everything leave it to dry.

• 

  Step 7

  Cut a piece of paper of the exact meaure as one of the sides (mine was of 32cm). Fold it a couple of times till you have the number of decorations you want.

• 

  Step 8

  Mark the folds of the paper on the fabric so that you know where to sew the decorations later.

• 

  Step 9

  This is what we'll need to make the decorations on the cover.

• 

  Step 10

  Introduce the head pin into the bead and make a loop by helping you with the pliers. I'm no expert in doing this so i'm no good for explaining it but here you a video that makes it really easy: http://www.youtube.com/watch?v=XYlYQL49WNQ.

• 

  Step 11

  Open one of the jump rings (here if you need tips: http://www.youtube.com/watch?v=zpcdZbglJAg), pass the loop inside od it and close.

• 

  Step 12

  Repeat the previous steps till to have all the beads ready to sew.

• 

  Step 13

  I said that this was "no-sew" but since this is so simple i don't think it really counts as sewing lol. Ok, so just sew the jump ring to the fabric exactly where you did one of the marks.

• 

  Step 14

  If you want, glue the back of the stitches so that they won't come off so easily. Let the glue dry.

• 

  Step 15

  And you're ready!

Comments

Leave your comment