Molotow Masking Fluid Marker

Learn how-to use a Molotow Masking Fluid Marker with Sunnyside Art Supplies

https://www.cutoutandkeep.net/projects/molotow-masking-fluid-marker • Posted by Shop Showcase

You will need

Molotow Masking Fluid Marker Pencil and paper to sketch out your design (black graphite Transfer Paper if you need to transfer your drawing onto your watercolour paper) Watercolour Brush Watercolour Paper Masking Tape Masonite Board (to tape down your watercolour paper on) Sea Salt (large granule) Watercolour Container of Water Eraser

Project Budget

Time

Difficulty

Description

Instructions

1. 

   Sketch out your design. Draw or use the black transfer paper to trace your drawing onto the watercolour paper. Tape down the watercolour paper down onto the Masonite board.

2. 

   Use the Molotow Masking Fluid Marker and trace over your entire drawing. Let the masking fluid dry completely, this won't take long at all. Paint a few washes of watercolour over your Molotow Masking Fluid drawing on your watercolour paper. TIP: ( make sure you have enough water and pigment in your paint brush to do a smooth clean wash in one go). Sprinkle a little sea salt on the watercolour paper where you want and it will soak up a bit of the colour leaving less colour behind.

3. 

   Wait until the watercolour paper is completely dried. After it is completely dried, brush off the sea salt with your finger and rub off the Molotow Masking Fluid with an eraser. Enjoy what you created!