Mixed Bracelet Watch Bands

In this project, I will teach you the way make interchangeable bead and chain bracelet watch bands, which do really evoke the sense of stunning ingenious bracelet patterns with beads.

Posted by

About

In this project, I will teach you the way make interchangeable bead and chain bracelet watch bands, which do really evoke the sense of stunning ingenious bracelet patterns with beads.

Share

You Will Need (11 things)

  • Watch face (with 6 connector ports) Watch
  • 3mm Round Seed Bead Seed Beads
  • Glue on crystals Glue
  • Jump Ring
  • Suede Cord
  • Large ring chain Chain
  • Glue
  • Tiger Tail
  • Lobster Claw Clasp Lobster Clasp
  • Wire-cutter Plier Wire Cutter
  • Flat Nose Pliers

Steps (4 steps, 120 minutes)

  1. 1

    Step1: preparation and adorn your suede

    1. Measure your individual wrist circumference and figure out how long each side would be;

    2. Cut your chain and suede to that size;

    3. Direct the suede cord through one middle-sized jumpring, with about 1cm long part. Fold the short tail and glue to itself to secure the jumpring;

    4. Do repeat the same process to 4 ends of 2 suede strands;

    5. Glue and secure the crystals onto suede cord neatly and evenly.

  2. 2

    Step2: Connect chain and suede cord to watch face firstly

    By using four small-sized jumprings, attach the chain strands and well-decorated suede cords to the four outer ports on watch face.

  3. 3

    Step3: work the rest bracelet patterns with beads

    1. Tie a string of tiger tail wire to the middle port and secure with another knot;

    2. Slide on the 3mm Round Seed Beads until it reaches to same length as your chain and suede cord;

    3. Tie and secure the end tail to another middle-sized jumpring tautly;

    4. Make a mirror image on the other side.

  4. 4

    Step4: add on clasp

    To the ending, collect three branches with a jumpring. Add on the clasp to either tip and this is your new bracelet watch bands.