Heavy Metal Bracelet
As seen in BEAD (issue 15 - April/May 2009)
Posted by Photobeads
About
FINISHED SIZE: 20cm (8")
Share
You Will Need (8 things)
- 4 silver plated 25mm semisphere metal Button(s)
- Flower Life pink Button(s) with bachelor buttons, primroses, hyacinth and fringed gromwells
- 4 silver coloured 5mm plastic Bead(s)
- 18 cm (7") silver plated 10x8mm Chain
- Toggle Clasp
- 14 silver plated 5mm Jump Ring(s)
- 8 silver plated 10mm Jump Ring(s)
- Pliers
Steps (6 steps, 20 minutes)
-
1
Using 2 small jump rings attach both clasp parts to the different ends of the chain to make a bracelet.
-
2
Divide the metal buttons equally over the whole length of the chain and mark the links where you want to attach the buttons.
-
3
Lay one button upside down and slide a marked link on. Use two small jump rings to connect the neighbouring chain links to the buttonhole. Put one more jump ring through the button hole and close.
-
4
Repeat step 3 with the rest of the metal buttons.
-
5
Use one large jump ring to attach a Flower Life button to the chain between two metal buttons. Use another large jump ring to attach a small plastic bead to the Flower Life button.
-
6
Repeat step 5 with the rest of the Flower Life buttons.
Not heavy at all!