Fused Scrapbook Page

  ✂︎

Favorite

Comment

List

       

Share

• Step 1

  Insert fusing head in Fuse tool. Plug in Fuse tool to allow to heat up; about ten minutes.

• 

  Step 2

  Cut scrapbook paper to size. I cut the paper to the size of the photos as backing so when the page was complete, the back side was just as nice as the front.

• 

  Step 3

  Insert photos into photo sleeves. My pictures were not 6” wide so I used the fuse tool to size the sleeve to my pictures. After the new seal was created, I cut the excess off.

• 

  Step 4

  Insert bottom photo and scrapbook paper backing into page protector and use the Fuse tool to seal it in. Attach the first photo sleeve a little above the photo in the page protector and fuse it in place. Do the same for the remaining photo sleeves. This will create a waterfall effect allowing more photos to be placed on the page.

• 

  Step 5

  Next, I started to fill the other side of the page with pictures and pockets of confetti. Using the fuse tool, I created the right hand pocket and inserted the first photo and sealed it in. Then I added the confetti and created its own pocket. I continued this until the right side was filled.

• Step 6

  I added a little saying on scrapbook paper and confetti above the waterfall photos and sealed them in. I then, added the last photo.

• 

  Step 7

  In the center of the page, I added scrapbook paper with the word Cake spelled out in letter stickers. Lastly, I added stickers and embellishments to the page protector.

Comments

Leave your comment