About this project
This tutorial is super fast and super easy!
Ettika is a jewelry company popular among celebs and fashionistas alike, and their works have appeared in a ton of fashion magazines as well. This bow bracelet is totally doable for a DIY, and it doesn't require mad skills to make!
This sells for $32 on their site. You can make yours for less than $3. Who needs to know?!
As you can see, I made mine in silver; I wear a lot more silver and I had extra silver chain and findings on hand. They make gold and silver versions, so pick whichever metal you like better.
Step 1: Gather materials. Needed are pliers, a paintbrush, clear lacquer, scissors, polka dot ribbon (Ettika makes green, blue and yellow versions of their bracelet so pick one of those colors), two jump rings, a clasp set, and chain.
My ribbon was about 1cm. wide, but it's ok if the size varies a little, it won't change the look entirely.
Step 2: Make the bow. Take your length of ribbon and make a loop in the center around your first finger (pic 1). Take the ribbon on the bottom, and loop back up around your first finger, over your thumb. Take the ribbon to the back of your first finger (pic. 2). Pinch the first loop you made along with the part we just took over the thumb with your other hand (pic. 3). There should be a small opening at the right to pull that ribbon from pic. 2 thru. Pull to form the bow. The arrows show you which way to pull the ribbon.
Step 3: Finish bow. Take you paintbrush and paint the back of the knot really good with lacquer to "glue" the knot in place. Then, cut the ribbon ends into triangles to create that cute cut look. I cut mine about 2.5cm from the center knot. Then, paint lacquer on the back edges of the ribbon to prevent fraying.
Step 4: Add chain and finish. Measure your wrist to cut the correct amount of chain. The bow will be about 2" long. I needed my bracelet to be 6" long. I needed 4" of chain on each side, 8" of chain total. You need to double the amount of inches of chain you need on each side of the bow because you will be making a loop, and essentially cutting the entire chain length in half by doing so.
Loop these two chain lengths through the loops in the bow.