Dragonglass Necklace

About

You Will Need (7 things)

Steps (6 steps, 30 minutes)

1. 1

   Cut 2 pieces of wire.

   Wrapping the Arrowhead: Part 1

   • Place Wire 1 centred behind the arrowhead and bring both ends forward in an upwards V-shape
   • Twist together up to the top of the arrowhead

2. 2

   Flip the arrowhead over.

   Wrapping the Arrowhead: Part 2

   • Place Wire 2 centred behind the arrowhead and bring both ends together at the centre.
   • Twist once and then bend straight upwards, flat against the arrowhead

3. 3

   Flip the arrowhead over again.

   Wrapping the Arrowhead: Part 3

   • Use Wire 1 to create a loop about 5mm above the top of the arrowhead. (I used a pencil to make the loop - I would recommend a smaller item as mine turned out far too big)
   • Leave approximately 5mm of wire after the loop and cut off the remainder.

4. 4

   Flip the arrowhead over again.

   Wrapping the Arrowhead: Part 4

   • Separate the two ends of Wire 2
   • Cut the right end off at the length that it lines up with the Wire 1 loop
   • Use the left end to tightly wrap the 5mm lengths of wire up to the loop, then cut off the remainder.

5. 5

   Attach a jump ring to the loop of the wire-wrapped arrowhead and thread a length of black cord through.

6. 6

   Finnish each end of the cord with a fold-over cord end.

   To one fold-over cord end, add a jump ring connected to a lobster clasp.

   To the other, add a jump ring connected to a short piece of chain.