Diy Rope Knot Headband

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  What you will need:
  Rope (you can pick any diameter depending on your preference) - roughly 2 meters
  4 rope end caps
  4 jump rings
  An elastic band
  Tape
  Glue gun
  Plyers
  Scissors
  Wire

• 

  Step 2

  Start by prepping the rope end clasp. Cut a piece of wire and fold in half into a loop shape.

• 

  Step 3

  Take the ends of the wire and insert into the hole of the rope end clasp.

• 

  Step 4

  Repeat steps 1 and 2 three times to create the wire loops for all 4 end clasp. Set aside.

• 

  Step 5

  Take your rope, leaving about 8-10 inches of lenght on one end and create your knot, like a figure eight. Start the figure eight shape by first overlapping the rope as seen in the photo below.

• 

  Step 6

  Continue the figure eight shape by tucking the rope underneath as shown below.

• 

  Step 7

  Take the end and loop it through back the top loop of the figure eight.

• 

  Step 8

  Pull gently and adjust the length of the two sides to ensure it wraps around the crown of your head.

  Tape the end of the uncut side, and then cut the rope.

• 

  Step 9

  Repeat the same figure eight shape by first inserting the second strand of rope through one top half of the figure eight loop.

• 

  Step 10

  Pull the second strand of rope all the way through to match the first rope.

• 

  Step 11

  Continue to follow the figure eight shape with the second strand of rope.

• 

  Step 12

  Once you have the two ropes in the figure eight knot and also have adjusted and trimmed the rope to length (matching the crown of your head), heat up the hot glue gun and squeeze glue into the inside of the end clasp and insert the end of rope, repeat for each one.

• 

  Step 13

  Attach a jump right to every end with the elastic band as shown.

• 

  Step 14

  Here you have it! Final product!

Comments

Leave your comment