Diy Rope Bracelets

Do you want to make your own super easy, simple and knotted rope bracelet patterns? It’s not as hard as you would think! We present to you a detailed DIY rope bracelet project that includes clear illustrations and an elaborate explanation.

Posted by

About

Do you want to make your own super easy, simple and knotted rope bracelet patterns? It’s not as hard as you would think! We present to you a detailed DIY rope bracelet project that includes clear illustrations and an elaborate explanation.

Share

You Will Need (9 things)

  • Nylon Thread
  • Ribbon Ends
  • Jump Ring
  • Lobster Claw Clasp Lobster Clasp
  • Tag Connector Connectors
  • Flat Nose Pliers
  • Glue
  • Toothpick
  • Scissors & Tape (not shown) Scissors

Steps (5 steps, 45 minutes)

  1. 1

    Step 1: Create the focal knot

    1. Prepare two strips of cord, each about 50cm long. Wrap the tips with tape so that they don’t fray away while making the knot;

    2. Fold one cord in half. Make a loop where the cords overlap each other as shown in the picture;

    3. Also fold the 2nd cord, however, insert it under the loop;

    4. Take the folded tip of the 2nd cord and pass under the tails of the loop;

    5. Still working with the folded part, thread it through the loop from left to right over-under-over;

    6. Tighten the knot slightly. Pay attention to how you work with the cords, trying to keep them flat for a better looking and even rope bracelet pattern.

  2. 2

    Step 2: Cut off the excess parts

    Measure the length that you desire for the bracelet. Then, place a piece of tape all the way around the four strands where you will make the cut.

  3. 3

    Step 3: Add on the clasp

    1. Remove the excess cords and then dab drops of glue to the cut ends;

    2. After the glue has completely dried, attach a wide ribbon end. Squeeze tightly;

  4. 4

    3. Repeat the same process on the other side;

    4. Add on the clasp and tag connector by using two jumprings.

  5. 5

    Congratulations!