Diy – Garden Bucket Tool Belt
For your favorite gardener.
Posted by gardenmatter
About
Learn how to make a toolbelt for a garden bucket which you can use to haul around the garden carrying your tools, seeds and other gardening necessities.
Share
You Will Need (4 things)
- 4 yd -1/2 inch Double Fold Bias Tape
- 1 ¼ yd - 1 Inch Cotton Twill
- ¾ yd - 1 yard Sturdy fabric (duct or heavy Twill , denim)
- 2 D Ring(s)
Steps (5 steps, 240 minutes)
-
1
Cut the fabric as shown:
-
2
Sew the bias tape on the small pocket first.
Press 1/4 inch of the sides and bottom of pocket.
Place the pocket on long piece (Part A), face down with bottom edge 2 inches from the edge and sew.
-
3
Flip over and top stitch sides. Then sew another line of stitching about 1/3 of the way in to make 2 pockets within the pocket.
Sew bias tape on top of Part A.
-
4
Next pin Parts A and B together lining up the bottom edge with the right sides showing.
Pin the top corner of Part B sides to match Part A.
Fold the excess fabric in from the sides at an angle and cut.
Sew side and bottom edges of Part A to Part B.
Then sew a line of stitching on both sides of the small pocket from the bottom.
-
5
Then sew the bias tape all along the sides and bottom.
Repeat with the remaining pieces. (except for the small pocket)
Then attach the two sections together with the 1 inch cotton twill trim at the top leaving enough space between the two pieces to fit around the handles. I used two rows of stitching for stability.
Turn in 1 inch of the end of the trim and sew.
Sew D rings on the other end of the trim and you are finished.