Diy Busy Box For Boys

Upcycled hardware make for great busy box components!

Posted by Andrea Arch

About

I found most of the components at several West Michigan Restores. It was like a treasure hunt digging through all the bins finding just the right things that clicked, spun, opened, dinged, boinged and latched.

Share

You Will Need (5 things)

  • Straps
  • Paint
  • Hardware
  • Drill
  • Press Board

Steps (1 step, 600 minutes)

  1. 1

    I opted to go with pressboard to cut down on splinters and used a handheld router to round all the edges for safety purposes.

    Three slits were cut down each end so that velcro scraps can be used to secure the board to a piece of furniture or other sturdy object. This beast weighed quite a bit when it was all said and done, so I would highly recommend taking some sort of action to stabilize it rather than just lean it against a wall.

    A lot of the pre-used gadgets had some wear and tear, so most of them were spray painted to give 'em a fresh look. I used gold, silver, black and white spray paint to keep everything looking cohesive.

    I used extra pressboard to create two 6"x6" doors... one opening to the side and the other opening at the top. I created little picture sleeves out of black binding covers and a transparency.