Cut Out + Keep

Chiped Skateboard Repair Job

it's like recycling or frugality ;-)

https://www.cutoutandkeep.net/projects/chiped-skateboard-repair-job • Posted by HIGHFIVE

...so on OCT.12th i took a break from my 16-or-so day bender i had been on , of skateboarding everyday , to fix my damaged skateboard 'deck'. and while entering info about my crafts onto 'cut out + keep' i let it dry (glue). but tday i kicked-off my next bender i guess , and partied-down with my fixed-up board ... i skated hard and the fix is holding good.

You will need

Project Budget
Almost Nothing

Time

0 h 20

Difficulty

Nice & Simple
Medium img 2604 1287069401

Description

...so on OCT.12th i took a break from my 16-or-so day bender i had been on , of skateboarding everyday , to fix my damaged skateboard 'deck'. and while entering info about my crafts onto 'cut out + keep' i let it dry (glue). but tday i kicked-off my next bender i guess , and partied-down with my fixed-up board ... i skated hard and the fix is holding good.

Instructions

  1. Small img 2609 1287069763

    #1 first i seperated the 'plys' of the 'deck' at the damage spot and kept them open for pouring glue in by pushing nails in as far as i could WITHOUT causing more damage.

  2. Small img 2610 1287069634

    #2 here i've reached the point where i'm ready to pour-in glue

  3. Small img 2613 1287070047

    #3 when adding glue i try to get it into the depths of the damage zones as deep as possible , mindfull of the fact that i can add more but not adding so much that it makes a mess when squeezed for drying.

  4. Small img 2614 1287070284

    #4 during adding glue i switch between adding glue , & squeezing/moving it around to all points possible ... one tool i used for this was a thin safety-pin , to pke the glue in deeper.

  5. Small img 2616 1287070479

    #5 after spreading glue where needed (in-between ALL deck-plys possible)i pull out the nails used to keep open spaces for glue and ...

  6. Small img 2618 1287070692

    #6 ...decide if it needs more or if it's ready to be clamped and left to dry.

  7. Small img 2619 1287070793

    #7 here's what i did , give it a good squeeze and let the glue spread .

  8. Small img 2622 1287070907

    #8 then i put things over the 'chips' that i want to squeeze with the clamp to ensure more even pressure from the one clamp .

  9. Small img 2626 1287071059

    #9 also i was sure to lean the board in a direction to prevent out-leaking glue from running to where i don't want it.

  10. Small img 2629 1287071648

    #10 i let one side dry for a while before standing it on-end and fixing the other end , to avoid wet glue running.

  11. Small img 2634 1287071457

    #11 ,hours later i felt it was surely dry so i took-off the clamps...

  12. Small img 2640 1287071837

    #12 ...then i used some sandpaper on a block to smooth-away some dried-glue lumps & bumps .

  13. Small img 2644 1287071999

    #13 VOLA , it's ready for the next day of skateboarding.