Bustling Flower Watch
Flower Bracelet Charm Watch
Posted by Sooz in the Shed
About
A bustle of beautiful lucite flower cups in bright springtime shades, linked across a chain with a watch face as the focal.
Share
You Will Need (9 things)
- 1 Watch Face (with loop attachments)
- 16 cm Wide Link Chain
- 60 Flower Beads
- 60 6mm Glass Beads
- 60 50mm Headpins
- 1 Toggle Clasp
- 5 g Sz 11 Seed Beads
- Wire Cutters
- Round Nose Pliers
Steps (8 steps, 180 minutes)
-
1
Measure your watch face and cut your chain to make
your bracelet up to a total length of 8” (larger or
smaller if required) -
2
Cut your chain in half and add a clasp part to each
piece. -
3
Onto a headpin thread a small seed bead followed by
a 6mm bead and a flower cap to sit on top of the bead. -
4
Bend the pin (do not cut any wire off at this stage) and
loop onto one of the links on your chain. -
5
Form the wire around into a loop enclosing the link,
and wrap the wire round the head of the flower cup
twice.
Nip off the wire close to the cup and make sure it is
tucked in neat so no sharp bits protrude. -
6
Add TWO flower pins to EACH link, fill up both lengths
of chain as shown in the pic. -
7
Open the link on the watch face and add the flower
chain.
Repeat for the other side.
You may like to add a couple of flower pins to the
actual watch link too to add more fullness. -
8
Wear with pride !