Bridal Tiara

This pretty delicate tiara is perfect for that special day.

https://www.cutoutandkeep.net/projects/bridal-tiara • Posted by Beads Unlimited

This pretty delicate tiara is perfect for that special day. The twisted silver plated wire holds pearls and Swarovski Crystals in the air to catch the light and add extra sparkle.

You will need

1 x 115mm Tiara Base silver plated 0.4mmx20m silver plated Wire 10 x 6mm Swarovski Crystals , round 4 x 6mm Swarovski Crystals , round 17 x 4mm round high quality Glass Pearl Beads cream 8 x 6mm round high quality Glass Pearl Beads cream Pliers

Project Budget

Time

Difficulty

Description

This pretty delicate tiara is perfect for that special day. The twisted silver plated wire holds pearls and Swarovski Crystals in the air to catch the light and add extra sparkle.

Instructions

1. Cut approximately 12cm of wire, thread on a bead of your choice, bend the wire in half and gently twist the wire loosely together. Repeat to make 20 strands. Use a Swarovski crystal and a 4mm pearl on four strands and single beads for the others.

2. Start in the middle of the tiara band, wrap the ends of one strand tightly around the band Use the flat part of the pliers to flatten any sharp pieces of wire.

3. Repeat for all of your twisted wires, Work out from the centre keeping them close together. You can trim some of the wires to make a variety of lengths for the decorated section.

4. 

   This is what your finished tiara should look like.