Bow Waist Belt

You'll want to make this super cute Bow Waist Belt in every color and pattern.

Posted by Thera Joyce

About

I've been seeing these cute bow waist belts all over the place. I am so in love with them! The only problem is, some of them are pretty pricey. I decided to try my hand at making one and it came out great!

Share

You Will Need (8 things)

  • Scrap Fabric
  • Thread
  • Tailors Chalk
  • Pin(s)
  • Craft Fuse
  • Velcro
  • Needle
  • Measuring Tape

Steps (19 steps, 45 minutes)

  1. 1

    You'll need to take your waist measurement. A waist belt sits at belly button level. Make sure the measuring tape isn't too snug. If you want your belt to sit lower, measure where you'd like it to sit.

  2. 2

    Add 5 inches to your waist measurement. Your belt will be 4 inches wide so add 1/4 inch for seam allowances. Cut two.

  3. 3

    Measure out a 6 inch by 7 inch square. Cut two. This will be your bow.

  4. 4

    Now measure out a 2 1/2 inch by 6 inch rectangle. Cut 1. This will be the tie for the bow.

  5. 5

    You will need to cut 1 belt piece and one bow piece out of the Craft Fuse (extra firm iron on interfacing). I usually just use the pieces I've already cut out as pattern pieces. Just lay them on top of the Craft Fuse and cut!

  6. 6

    Iron the Craft Fuse onto one piece of the belt and one piece of the bow. Make sure you iron the Craft Fuse onto the wrong side of the belt and bow piece.

  7. 7

    With right sides together, stitch along the outside edge of the belt pieces. Make sure to leave a small hole for turning the belt right side out. I left my turning hole along one of the long sides of the belt.

  8. 8

    Using pinking shears, cut the excess seam allowance off. Make sure you don't cut into your stitches.

  9. 9

    Now turn the belt right side out. You can use your iron to press the edges of the belt flat.

  10. 10

    Topstitch along the outside edge of the belt. This gives the belt a nice finish and also closes your turning hole. Set the belt aside.

  11. 11

    With right sides together, stitch the bow pieces together. Make sure to leave a turning hole.

  12. 12

    Turn the bow right side out and use your iron to flatten the edges. Topstitch along the outside edge of the bow.

  13. 13

    Now, fold the bow tie in half so it's width is now about an inch. Stitch down the long side of the piece.

  14. 14

    Turn the bow tie right side out and press flat. I usually press this piece so the seam is in the center of the back of the piece. Set the bow pieces aside.

  15. 15

    Try the belt on and position the velcro where you'd like. Pin.

  16. 16

    Stitch the velcro to the belt.

  17. 17

    Now grab the large part of the bow. Gather the bow by sewing a running stitch down the middle of the bow. Gather, then wrap the excess string around the center of the bow a few times.

  18. 18

    Now stitch the bow tie around the center of the bow.

  19. 19

    Put the belt on again and position the bow where you'd like. Pin. Stitch the bow onto the belt.