Bold Bicone Jewellery Set

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Thread a 4mm bicone onto an eyepin, using the cutting part of the pliers trim the eyepin approximately 1cm above the bead. With the round nosed part bend into a loop and close. Repeat for all of your bicones.

• 

  Step 2

  Join the beaded eyepins by opening and closing the 8mm jump rings with the multi pliers. Make four lengths of 21 bicones, one length of 3 bicones and one length of 8 bicones.

• 

  Step 3

  Cut an 11cm length of wire. Approximately 4cm from the end of the wire bend a loop and wrap the short end around the wire underneath the loop. Thread on a glass flattie bead. Make a loop in the wire underneath the bead and bend the rest of the length around. Use the pliers to squeeze in any sharp ends on both sides.

• 

  Step 4

  With a jump ring attach the 8 bicone length to the loop at the red end of the flattie bead. Attach a jump ring to the other end of the 8 bicone length.
  Attach a jump ring and a trigger clasp to one end of the 3 bicone length.

• 

  Step 5

  Attach a jump ring to the other end of the 3 bicone length, join the ends of each of the 21 bicone lengths and close the jump ring.

• 

  Step 6

  Attach a jump ring to the bottom of the two tone flattie bead. Pick up the first length of 21 bicones; join the sixth jump ring from the end to the open jump ring. Take the next bicone length and attach to the fifth jump ring. Add the next length on the fourth jump ring and the final length on the third jump ring from the end. Close the jump ring. Make sure the lengths are lying evenly.

• 

  Step 7

  To make the earrings
  Follow step 3 and attach a long ballwire to the loop at the clear end of the bead. Attach a jump ring to the bottom loop and add bicone lengths in the following order:
  2 bicones, 3 bicones, 4 bicones, 3 bicones and 2 bicones.

• 

  Step 8

  To make the bracelet
  Follow step three. Attach a jump ring to each side. Make eight lengths of two bicones with three jump rings, attach four to the jump rings each side of the bead. Add a jump ring to the four end jump rings on each side. Add another bicone and jump ring to one end and attach a trigger clasp. Add another two bicones ending with a jump ring on the other end.

• 

  Step 9

  This is what your finished set should look like.

Comments

Leave your comment

man m. 18th December 2018

Thanks for sharing.I found a lot of interesting information here. A really good post, very thankful and hopeful that you will write many more posts like this one.
<a href="https://www.ucbrowser.vip/">ucbrowser.vip</a>
<a href="https://shareit.onl/">shareit.onl</a>
<a href="https://mxplayer.pro/">mxplayer.pro</a>

Reply

Rozantia P. · Sofia, Sofia-city, BG · 41 projects 24th May 2012

Gorgeous!

Reply

Debra C. 21st July 2010

I Love this whole set! Great Job!
Debbi C.

Reply