Atc's And Business Cards

About

You Will Need (2 things)

Steps (9 steps, 60 minutes)

1. 1

   I went through my W magazines with my masked grid ruler to see if the face and one hand would make it into the space.

2. 2

   I then cut the ATC out with the scissors that I die cut using the Provo Craft scissor die cut roughed in.

3. 3

   To attach the scissors to the card I cut a piece of 26 gauge wire about 4 inches, bent it in half with a tiny silver bead in the fold and slid each half of the scissors on both wires.

4. 4

   I punched a tiny hole in the card and slid the wires through.

5. 5

   I then folded the wires to the side just as you would a brad and curled them into a loose flat question mark going in opposite directions.

6. 6

   I printed the words "Cutting Edge Crafter" out on sticky back paper in a whole bunch of different fonts and sizes.

7. 7

   I cut them out and stuck on ones that I felt worked in each space.

8. 8

   I will stick on the back all my pertinent info for trading the ATC's.

9. 9

   I liked how the ATC's came out so I thought I'd try business cards. What do ya'll think? I kinda like them, but am I prepared to make enough to hand out? Hmmmmmmm.