An Awesome Box From Recycled Junk Mail

About

You Will Need (5 things)

Steps (12 steps, 15 minutes)

1. 1

   You will need -

   Junk Mail Card Stock (any type)
   Ruler
   Pen
   Exacto Knife
   Hot Glue Gun

   You can use what ever type of glue you would like or even tape. I just like to use hot glue because it dries the fastest.

2. 2

   Measure in 1" from the edge of your cardstock and mark.

   Do this at intervals around all four sides.

3. 3

   Connect your marks so that they make a straight line along each side. Be sure to draw all of the way to each edge so that the lines intersect at the corners.

4. 4

   Using heavy pressure run your pen up and down each line a few times to "score" them for folding.

5. 5

   Measure the length of your card stock and divide it in half to find the center. Lightly mark a center line.

   Now mark a 1/2" on either side of this line. Repeat on the other edge.

6. 6

   Connect your marks and use heavy pressure to score these lines also.

7. 7

   With the long side of your cardstock horizontal, and using the lines as guides, take your exacto knife and cut the flaps as shown.

   Be careful not to cut above your 1"mark.

8. 8

   Fold along all of the lines you have made.

   I prefer to keep all of my markings hidden on the inside.

9. 9

   Fold your box into it's basic shape to try it out and see if you have your sides even.

   This is where you will find out if you can draw a straight line and how good your math was when you found the center of your sheet.

   If everything is right it should fold up just like a clam shell.

10. 10

    You will have 3 open sides and a solid one. Hot glue the side directly opposite of the solid one.

11. 11

    Pick one of the other open ends and hot glue that together.

12. 12

    And you should now have a super awesome recycled box!