Alternative ..Add A Disc To An Earring Post
This is similar to my other adding a disc to a post at a set size
Posted by Rebecca Skeels.
About
As I said in the previous project, I was asked for some advice on soldering a earring post to a very small disc, with some precise measurements. So I provided these intructions and the other project instructions to the customer.
Share
You Will Need (7 things)
- Wire
- Tube
- Snips
- Solder
- File
- Ruler
- Nail Buffer
Steps (12 steps, 60 minutes)
-
1
Purchase wire and tube to customers specifications. Make sure the inside diameter of the tube is the same as the diametre of the wire.
-
2
Slide the tube onto the end of the wire.
-
3
It is best to saw the tube at the required legnth, but if you only have snips, they will work too. If using snips cut a little extra.
-
4
Solder the tube to the wire with hard solder.
-
5
File the end flat.
-
6
Measure and mark the wire to the required legnth.
-
7
Snip or cut to legnth, again cut a little extra if cutting with snips.
-
8
File the end flat
-
9
Round and smooth so it is comfortable for someone to put in their ear.
-
10
File in a groove near the end of the wire.
-
11
All finished, and happy customer.
-
12
Remember to write up your notes for your technical file.