QWERTY keychains

anyone know how to make holes in the letter keys from the qwerty keyboards, so I can make keychains or rings, or whatever else comes to mind.

as seen at: http://www.toxel.com/wp-content/uploads/2008/12/keychains23.jpg

thanks !

Edit Delete
Moderate: Hide this post Mark as Spam
1 reply since 26th August 2009 • Last reply 26th August 2009

Reply #1:

I think a dremel is what you're supposed to use, and then you'd just sand the hole edges so they're not busted or sharp. Or you can use a screwdriver with a very tiny bit. Same goes for the sanding.

Edit Delete
Moderate: Hide this post Mark as Spam


Reply