Twisted Bracelets

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Cut 4 strands of twine that are the same lenght.

  (This will be for the inside of your bracelet. If you want it thicker, add more strands.)

• Step 2

  Now cut a strand that is about three times as long as the other strands. (You will use this strand to wrap around the others.)

  Note: the thicker your bracelet (aka- the more strands in your inside bracelet), the longer this string needs to be.

• 

  Step 3

  Take your 5 strands and make them all even at the top, like so.

• 

  Step 4

  Tie these into a knot (any kind of knot).

• 

  Step 5

  Now, take your longest strand and pull it behind the others, as shown in the picture.

• 

  Step 6

  Pull it around infront of the other strands and down through the hole as the picture shows.

• 

  Step 7

  Tightly pull the knot you just made.

• 

  Step 8

  Continue these knots (steps 5-7). The knots will naturally twist all the way around the bracelet.

• 

  Step 9

  If you wish for beads, right before you make the knot, add the bead.

• 

  Step 10

  Then just finish the knot shown in steps 5-7, only now with the bead. Pull tightly.

• 

  Step 11

  Tighten this knot. Now you can continue with the knots shown in steps 5-7.

• 

  Step 12

  When desired lenght is reached, make a sturdy knot at the end and cut off the excess twine. Then you can tie it to your beginning knot.

  (=

Comments

Leave your comment