Make and Share Craft Tutorials
About
Published
over 3 years ago
Time
Difficulty
This batty bracelet design is the creation of Ornamentea.com, your source for fine craft ingredients, tutorials & project ideas!
All supplies and tools are for sale at Ornamentea.com
Tags
Crafts
Instructions
You Will Need
- 1 Long Brass Bat Charm(s)
- 5 Antique Brass Jump Ring(s) , 7mm
- 3.5 inch Antique Brass Extender Chain
- 1 Brass Spring Ring Clasp(s)
- 2 Tiny Brass Owl Charm(s)
- 1 Baking Tray
- 1 Antique Brass Head Pin(s)
- 1 'Red Swarovski Crystals hinestone Ball
- 1 Wire Cutters
- 1 Round Nose Pliers
- 1 Chain Nose Pliers
- Project Cost
- Cheap
-
1
Using your round pliers bend the tip of one bat wing around to form a loop as shown. Repeat with other wing tip.
-
2
Using your hands, gently bend the brass bat into a curve that fits the front of your wrist.
-
3
Using your cutters, cut extender chain into two sections, on 2 inches, one 1 1/5 inches long.
Thread Swarovski rhinestone ball onto head pin and loop using round nose pliers. Open loop on rhinestone ball and attach to 1 1/5 inch chain section. Using your chain nose pliers attach spring clasp to 2 inch chain section.
Using your chain nose pliers and jump rings, attach chain sections to each bat wing using two jump rings on the end of each wing for strength. Close jump rings securely.
-
4
Use remaining jump rings to attach both owls back-to-back as shown to create a two-sided owl charm near the clasp.
Comments
Recent Favorites
