First , you need studs .

You can either buy brand new studs & takes those off a belt .

& you will need a foam sheet .

The colour is up to you . I opted for black because it goes with everything :D

Cut foam according to whatever size your wrist is after measuring .

Be sure to leave extra space to add snap fasteners so you can open & close the bracelet .

Just use the studs & start poking them through the foam sheet after it's been cut .

It'll go through easy because the foam is soft & the stud backs are sharp (:

It'll look like this (:

Continue until you finish the whole bracelet .

Use the snap fasteners .

Either hot glue them on , or sew them . They work either way .

& you'll have a stud bracelet :D

& you can even make rings , chokers , & so on .

Good luck!