Spike Bracelet Diy

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Large chain
  1 Bracelet closure
  2 Jump rings
  Ribbon
  3 Large Spikes
  Pliers
  Loctite or another glue to hold spikes
  Fabric glue

• 

  Step 2

  Measure your wrist and cut your chain one link shorter than your wrist.

  When you add your closure it will add length to your chain.

  Use your jump rings to add your closure to your chain.

• 

  Step 3

  Depending on your ribbon you may want to cut it down the middle to make it thinner.

  Measure your ribbon to be about 2 and a half times as long as your chain.

  Starting in the middle of your length of ribbon, at one end of your bracelet, start wrapping your ribbon around your chain going down the entire length of your bracelet.
  Do the same thing for the other side.
  When you get to the end, tie your 2 ends of your ribbon together in a knot and secure with a small amount of fabric glue.

• 

  Step 4

  Lay your wrapped bracelet out flat and decide where you want your spikes to go.
  Have your Loctite ready to secure your spikes.
  Push the screw part of your spike through your wrapped chain, coming up through the bottom.
  Put a small amount of Loctite inside your spike and screw it on to the screw part of the spike.
  Repeat this for your other 2 spikes.

• 

  Step 5

  Let your glue dry.

• 

  Step 6

  Back view of spikes.

• 

  Step 7

  Finished!

• 

  Step 8

  My inspiration to make this bracelet.

Comments

Leave your comment