Snow Fox Tail

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  wrap yarn around ruler 15 or so times (Note: you can do a different length, but I used s ruler) cut at one end and then tie a not at on of the new ends.

• 

  Step 2

  braid from the not till you get about 3inches from the end. tie it off with string.

• 

  Step 3

  take pet hair brush and brush out end of tail. start from the bottom and work your way up. lots of yarn bits will come out on the brush.

• 

  Step 4

  take a 3inch by 3inch cardboard square and wrap yarn around it 20 to 30 times. tie I piece of string at the top (as tightly as possible). cut it at the bottom.
  NOTE: you will be making a BUTT-LOAD of these so be prepared O_O

• 

  Step 5

  it will look like a tassel

• 

  Step 6

  brush it out with the pet hair brush until its fluffy and looks like fur. leave the tow ends of the string alone

• 

  Step 7

  after you make a few, start tie-ing them on. tie them about 1 cm apart on the braid. this is hard to explain, but as you go upward, tie it in a circular spiral 'thing' (side 1, side 2, side 3, side 4, repeat)

• 

  Step 8

  continue all the way to the top

• 

  Step 9

  when you get to the top, I took a needle and some string and sew up the top so it doesn't come apart

• 

  Step 10

  sew on a loop at the top and your done

Comments

Leave your comment

Brigit · Baltimore, Maryland, US · 2 projects 23rd November 2015

Reply