Simple Wire Bow Torc

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  For this project, I used a rose-gold jewellery wire (0.6mm), round nose pliers and flat pliers.

• 

  Step 2

  This project follows a torc bracelet shape, which creates an open curve that fits around the wrist. To start, I place the end of the wire in the centre of my wrist and create a curve that looped to the centre underside of my wrist (use the round pliers ot help mould if needed), back to the centre:

• 

  Step 3

  ...where I secured the end with a few spirals of the wire, which I then made flush with the flat pliers.

• 

  Step 4

  Repeat the curve on the opposite side and cut the wire, securing in place with loops and the flat pliers.

• 

  Step 5

  ..

• 

  Step 6

  Trim the ends and then bring them to the front of the bracelet and make flush with the flat pliers (this will stop any scratching from sharp ends).

• 

  Step 7

  Next, make the bow embellishment. This was simple made by cutting a 10cm length of wire and making a looped bow design - I opted for this continuous design to avoid any sharp ends, but whichever bow design your prefer can be used.

• 

  Step 8

  To finish, I wrapped the end of the wire around the centre, trimming and then making flush at the back to hide the ends.

• 

  Step 9

  Finally, with a generous dot of hot glue, I attached the bow to the centre of the torc.

• 

  Step 10

  ...

• 

  Step 11

  ...

• 

  Step 12

  If you would like the make the bracelet more secure, or to add further pretty, loop a ribbon between either end.

• 

  Step 13

  This makes a pretty, simple and classic addition to stacked bracelets. Do try it yourself.

Comments

Leave your comment