• All
• A to Z
• Contests
• Crafty Superstars

Add to Favorites Add Your Version

1. 

   

   Cut your beading wire into 2 50cm lengths. To attach your bolt ring tag, pass the 2 lengths of beading wire through 1 crimp and through the joining ring of your tag. Then pass both lengths back through the crimp. Use crimping pliers to shut the crimp tightly and then again to fold to a neat finish. If you are using half round nosed pliers, just flatten the crimp.

2. 

   

   On each length of beading wire, pick up 8 dagger beads in random colours. Then pass 1 of the lengths through a millefiori bead from right to left. Pass the other length through the same bead from left to right. Repeat 9 more times. As you did before, add 8 more beads on each length. Then pass both lengths through another millefiori bead but this time, both in the same direction.




3. 

   

   Add your bolt ring as you did your tag by passing the 2 lengths of wire through a crimp and through the joining ring on your bolt ring. Pass both lengths back through the crimp and press the crimp tightly shut. Trim off any excess wire.

4. 

   

   Your finished bracelet should look something like this.

See more Jewellery Making or Beadwork