Pearl And Chain Fringe Necklace Diy

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  Step1: chain preparations

  1. Cut 20cm long sections of each type of chain;

  2. Add one jumpring at one end to hold three strands together;

  3. Slide one pearl bead onto Eyepin, form a simple loop at the other end and remove the excess pin;

  4. Cut another three strands of 5cm long chain;

  5. Open the two loops on eyepin and hook the last links of chain strands, one for the long and the other for the short;

  6. Design the central focal chain part. You may need to keep your chain about 10cm long. After that, connect it with the short chains by the component consist of eyepin and one pearl bead;

  7. Make a mirror image for the other side.

• 

  Step 2

  Step2: design the fringe part

  In my fringe necklace diy, the fringes are simply made up of chains and pearl beads.

  1. Snip 5 pairs of chain segments, the length should be like: 2.5cm*4, 5cm*4 and 7.5cm*4;

  2. Match 10 pieces of pearl beads with 10 headpins and loop the end as you did in above step. Then hook the 10 components onto the end of chains respectively;

  3. Make another 10 pieces of elements out of headpin and pearl bead. Affix the chain segments to the central long chain one after one. Make the pattern be symmetrical.

• 

  Step 3

  Step3: add on the clasp

  Add a large jumpring and your lobster claw clasp to the ends of necklace. Additionally, add on an extra chain to the side with clasp for a bit of cuteness you want.

• 

  Step 4

  Tada!

Comments

Leave your comment