Make and Share Craft Tutorials
About
Published
about 4 years ago
Time
Difficulty
I had a couple of babies that LOVED their paci! We had to have several on hand at all times. I remember frantically digging through the diaper bag looking for the elusive Binky, finally finding one stuck to the bottom of the bag, covered in crumbs and gunk! I wish I'd had one of these back then!!
This is a little Pacifier pocket that will hold several pacifiers. It is lined with vinyl (fused) fabric! This is a simple project that only took a few minutes to whip up!
My lables were designed and made by MommyMadeIt on etsy! Cute and great prices too!
Tags
Crafts
Instructions
-
1
Make a paper pattern. One piece is 4" x 6". The other is 7" x 4 ", taper the top of this one however you would like.
From outside fabric, lining fabric, and iron on vinyl cut 1 of each pattern piece.
-
2
remove vinyl from backing and place on the right side of your fabric.
-
3
place the paper, that you just peeled off the vinyl, shiny side down on top of the vinyl. Press with Iron set on Wool setting. It only takes a few seconds to fuse.
-
4
allow it to cool, and peel the paper off. Repeat with other lining piece.
-
5
Sew a 1" piece of Velcro about 1/2" down from the top of long piece. Sew lining together.
-
6
Cut a one inch square out of each corner.
-
7
Fold so side seam matches up with bottom seam and stitch across at 1/4".
-
8
Sew the outside together the same way that you did the lining. Sew the other half of the Velcro on the front, about 1/2" down from the edge.
-
9
Put lining inside of outer bag- wrong sides together.
-
10
Fold the top edges in 1/4"- 1/2", pin in place, then carefully stitch around the edge.
-
11
Your Paci bag is finished!! Embellish it with whatever you want, or leave it plain!
Comments
Recent Favorites
